The Daily Check of the Flotation Machine

The flotation machine is mainly applicable for separating non-ferrous metal, black metal, noble metal, non-metal mineral, raw body and materials of chemical industry, which are subject to coarse separation, swept separation, fine separation and flotation, so the useful ore are reclaimed.

Check the tension situation of the drive belt, the tightness degree should be suitable. If there is a severe wear, choose the belt with the same length and model to a set of replacement.

Check the tightness of the seal rubber ring, in particular, pay attention to that the grease in the bearing body should not leak into the pulp, so as not to affect the flotation working properly.

Check whether there is enough oil in the lubrication point, if the oil is less, add it promptly.

Check whether there is other debris in the flotation cell, if any, clean it up promptly.

The circulation of mineral slurry is reasonable, and can avoid the disposition of coarse sand to the largest extent. There is self-control device on the surface of mineral slurry, so it is easy to adjust it. The impeller has backward-inclined upper and lower vanes, which produce upper and lower circulation of mineral slurry respectively.

In the operating process of flotation machine, pay attention to check the following parts.

The rolling bearings in the motor and impeller body are ordinary. Generally, the normal bearing temperature should not exceed 35℃, the maximum temperature should not exceed 65℃, avoiding overheating.

The flotation machine has the advantages of large air-absorption capacity and low energy consumption. Every cell owns three functions: air absorption, slurry absorption, and flotation separation, and the cells form a flotation separation loop by itself without any auxiliary equipment, and is allocated horizontally, which favors the change of flow.